Make A Simple Veil

by Chica & Jo

Tutorial - Here is a tutorial to make a beautiful but simple design veil. As you plan your wedding, you’ll fast discover that most wedding-related things are quite expensive, and you can easily overspend almost without realizing it. One of the surprise costs as you shop for your wedding day attire is the veil, which can easily cost a couple hundred dollars for the simplestToolbox

• tulle
• needle and thread
• French comb or barrette
• ribbon for trim (optional)

Gather the supplies

The main thing you’ll need, of course, is some tulle (a.k.a. netting). This is available in any fabric store and can be found in 72″ and 108″ widths. For a fuller veil, use the 108″ wide tulle.

Cut the tulle

Lay the tulle out on a large table (or a clean floor) and keep it folded in half lengthwise (this is how it was at the store). Put the folded edge nearest to you. At this point you have two layers of tulle.

Now fold the tulle in half crosswise by grabbing the rightmost edge and folding it over so that it touches the leftmost edge. At this point you have four layers of tulle.

Measure again how long you want the tulle to be (from the top of your head down) and cut the tulle to that length (keep it folded) if needed.

Now round off the top left edge of the fabric by pinning to mark it and then cutting in a smooth motion. If you need a guide, try a large serving platter. You want to be left with a quarter-circle shape:

Arrange the layers

Unfold the tulle completely. At this point you have one layer of tulle. The dashed red lines below show where the folds used to be:

Fold the tulle crosswise from right to left, but you don’t have to bring it all the way over. You can match the ends up for a single-length veil, or you can leave a few inches between the edges for a nice layered look. If you keep a shorter layer, it can be used as a blusher if you like. At this point you should verify that the length is exactly what you want and if it’s too long, cut one of the rounded ends shorter, as needed.

Gather the tulle

You will now have to decide if you want the edges of your veil’s two layers to come all the way up to the top of the veil or not. If you choose to have the edges come up to the top, the top of your veil will be puffier. This decision is particularly noticeable if you plan to put a ribbon trim on the edges, because the ribbon will clearly be only at the bottom or will go up to your head, depending on your choice. This picture illustrates the two variations:

For the first look above, you will gather up only the center portion of your tulle, as seen in the first diagram below. For the second look above, you will gather the entire width of the tulle, as seen in the second diagram below:

Once you have decided how much tulle to gather, do so with a needle and strong thread, weaving in and out with small stitches. Pull the thread to gather the stitched tulle so that it is only about 2 inches wide. Knot the thread securely.

These photos show the gathering process on a short “center only” veil that I made for my niece to play dress-up with.

Attach the comb or barrette

Now take your gathered portion of tulle and sew it securely to either a simple French comb or a barrette.

 

You can still wear a fancy tiara or decorative barrette if you like; just place it right in front of your veil on your head. If you wish, you may also be able to sew the veil directly to the tiara, depending on its style.

Decorate the veil (optional)

Your veil is ready to wear at this point, but you may want to decorate it further. A popular finishing touch is to sew a thin satin ribbon along the edges of the veil. You can do so easily with a sewing machine and some white thread. When sewing, don’t bother to try to get the ribbon right up against the end of the tulle — it’s far easier to just leave some extra and then come back and trim it later.

Now go back with scissors and trim the excess tulle right next to the ribbon. And don’t worry about trimming it perfectly. Anyone more than 2 feet away from you will even be able to see it!

You may also choose to sew or glue tiny sparkling beads or gemstones randomly on your veil. If that’s what you like, then do it. It’s your veil, so it should be special and exactly the way you want it!

Congratulations! You’re done!

Here are two finished examples. Actual wedding veil is on the right. This veil pattern can easily be adapted to any length and many different styles, from the simplest of play veils for little girls who want to play dress-up to beautiful full-length veils for the bride. Oh, and don’t forget those girls who are preparing for their First Communion. They will need their own veil for the ceremony!